Instructions
Surface treatment: The wall should be dry, flat, firm and free of oil, with a moisture content of less than 10% and a pH value of less than 10.
Interior wall putty
(1). After the putty is completely dry, use fine sandpaper to smooth it and remove the powder.
(2). The putty should not be too soft, but should be firm, water-resistant and not cracked.
(3). Apply a coat of optimized and odorless interior wall primer.
Powdered surface
(1). Remove loose powdered dust.
(2). Apply a coat of optimized and odorless interior wall primer.
(3). If the wall is severely powdered and loose, it is recommended to completely scrape it off and apply new interior wall putty.
Moldy surface
(1). Remove mold.
(2) Dilute household bleach at a ratio of 1:10 and wash the wall. After it dries for 24 to 48 hours, rinse it again with clean water. After it is dry, apply a coat of optimized odor-free interior wall primer.
Technical Parameters
Ingredients: Special acrylic copolymer, pigments, fillers, additives, and water.
Gloss: Matt.
Theoretical Coverage: Approximately 10 m2/kg (one coat, based on a dry film thickness of approximately 34 μm).
Drying Time: Touch Dry: 1 hour (at 23°C and 50% relative humidity).
Hard Dry: 2 hours (at 23°C and 50% relative humidity).
Recoat Time: 4 hours (at 23°C and 50% relative humidity).
Volume Solids: Approximately 48% (varies depending on color).
Flash Point: Not Applicable.
Specific Gravity: Approximately 1.44 (varies depending on color).
Durability: Good.
Construction Instructions
(1) Read the instructions before application.
(2) Stir the paint after opening the can.
(3) The actual coating rate varies depending on the substrate, application temperature, application method, and color.
(4) Add an appropriate amount of water according to the instructions. Do not over-dilute the paint and stir evenly.
(5) Avoid getting excess paint on the paintbrush or roller.
(6) Do not pour diluted paint back into the original packaging.
